The jewelry box consists of four parts; base, top, top drawer, and bottom drawer. It can be hung on the wall with four Command Hanging Strips (that’s what I did) or there are keyhole openings in the back for screws. The top can be attached to the base with glue. The top drawer was about 2 mm too tall at the top when I printed it. I made the adjustment to the .stl file, but I have not printed it again for testing. In the photo, the top drawer is at the bottom and the bottom drawer is at the top.
I made the ring holders using foam rollers and 1 1/2″ velvet ribbon. I attached the ribbon to the roller with hot glue. I was perplexed about how I would go about getting ring holders the proper size to fit in the openings. I searched online for a while, finding many, but none that were the right size. Then I wondered if I could make them myself. I searched YouTube and lo and behold, there were many videos about how to make them. The one I found to be the most informative is below.
I am going to make one more print project with this mint filament before I change to the clear filament needed for the hamper stool project. I will post about that project next.
Links to files in Google Drive
Jewelry box base
Jewelry box top
Top drawer (subject to change)
Bottom drawer
License – Attribution, NonCommercial, ShareAlike 3.0